Q4/ For the cantilever beam shown below, If fc’- 28 MPa and fy- 420 MPa, then: a) Check the adequacy of the section for shear and torsion requirements, (30 M) b) Check if torsion design is required, if yes, then find the required stirrups area and the required longitudinal torsion reinforcement. Pu – 10kN

Report
Question

Please briefly explain why you feel this question should be reported.

Report
Cancel
Q4/ For the cantilever beam shown below, If fc’- 28 MPa and fy- 420 MPa, then: a) Check the adequacy of the section for shear and torsion requirements, (30 M) b) Check if torsion design is required, if yes, then find the required stirrups area and the required longitudinal torsion reinforcement. Pu – 10kN
in progress 0
Pantherion 2025-02-03T05:13:22+05:00 1 Answer 13 views Beginner
0
MathJax Example

Answer ( 1 )

  1. Mechanical Engineering Expert
    0
    2025-02-03T12:44:02+05:00
    Report Reply

    Please briefly explain why you feel this answer should be reported.

    Report
    Cancel

Leave an answer

Browse

By answering, you agree to the Terms of Service and Privacy Policy.