Report
Question
The stepped rod shown in sketch k is subjected to a tensile force that varies between 15,000 and 30,000 N. The rod has a machined surface finish everywhere except the shoulder area, where a grinding operation has been performed to improve the fatigue resistance of the rod. Using a 99% probability of survival, determine the safety factor for infinite life if the rod is made of AISI 1080 steel, quenched and tempered at 800C. Use the Goodman line. Does the part fail at the fillet? Explain.
The stepped rod shown in sketch k is subjected to a tensileforce that varies between 15,000 and 30,000 N. Therod has a machined surface finish everywhere except theshoulder area, where a grinding operation has been performedto ...

Please briefly explain why you feel this question should be reported.

Report
Cancel
in progress 0
3 months 1 Answer 5 views Beginner

Report
Question
A tension member in service has been inspected and a fatigue crack has been discovered as shown in sketch f. A proposed solution is to drill a hole at the tip of the crack, the intent being to reduce the stress concentration at the crack tip. The material is 30-mm-thick annealed AISI 1040 medium carbon steel, and was produced through forging. If the load is a completely reversing 15 kN and the original design is as shown,
A tension member in service has been inspected and afatigue crack has been discovered as shown in sketch f.A proposed solution is to drill a hole at the tip of thecrack, the intent being to reduce the ...

Please briefly explain why you feel this question should be reported.

Report
Cancel
0
3 months 0 Answers 2 views Beginner

Report
Question
A 230 kV three-phase power system is shown below. The base values are assumed to be 230 kV and 100 MVA. a) Find the bus admittance matrix of the system. b) Compute voltage at Bus 2 and Bus 3 for the first iteration using the Gauss-Seidel power-flow method
A 230 kV three-phase power system is shown below. The base values are assumed to be 230 kV and 100 MVA. a) Find the bus admittance matrix of the system. b) Compute voltage at Bus 2 and Bus 3 for ...

Please briefly explain why you feel this question should be reported.

Report
Cancel
0
7 months 0 Answers 6 views Beginner

Report
Question
El eslabonamiento está sometido a una fuerza de P= 2 KN. Determine el ángulo e necesario para el equilibrio. El resorte no está deformado cuando 0=0°. Ignore la masa de los eslabones.

Please briefly explain why you feel this question should be reported.

Report
Cancel
in progress 0
7 months 1 Answer 8 views Beginner